iCade button customisation.

[anthonyplep]

Hello everyone. I've been looking at this thread for a little and upon all the pages I didn't see anyone with this problem:

I got the switches mentioned in the first post, and installed them all fine, moved all the prongs and stuff down and everything. My problem that I'm having is getting the icade to close. It does not close very easily, you have to force it down a lot, and if it is tightly closed the 4 corner buttons don't seem to respond. Any suggestions? I was thinking about just screwing in half of the screws in the spots they'd need to be in the most but I'd prefer to get it to close correctly. Thanks


EDIT: I believe it was just the way the wires were going into the case, but its definitely fixed I'd say. All the buttons work nicely when closed tight now

[m44]

I just finished up my iCade modding. I got a good deal on the 6 Sanwa buttons. I may replace the other 2 and add a power switch eventually.

[Connector]

Good thread! Linked to the hdmi table of contents.

http://forums.toucharcade.com/showthread.php?t=173262